GENERAL TURNING Turning Inserts(Negative) WNMG Trigon60°,with Hole
- GF for finishing of general steel and alloy steel.
- Sharp tool nose and strong cutting edge.
- Good chip control under small cutting depth.
- QF for finishing of general steel and alloy steel.
- Curved edge,sharp cutting edge, good chip control and fine surface finish due to curved edge.
- SF for stainless steel and Heat
- Sharp edge due to results in low cutting forces particularly for thin wall structures and extended shafts.
- LF for stainless steel finishing to semi-finishing.
- Small blade width + large rake angle, increase the strength of the blade.
- Curved blade design, stable cutting flow direction control.
- GM for semi-finishing of general steel and alloy steel.
- Strong flat cutting edge.
- QM for semi-finishing of general steel and alloy steel.
- Gradient and waved hump wide applicable geometry range.
SKU: Turning Inserts(Negative) WNMG Trigon60°,with Hole 1
There are no reviews yet.