GENERAL TURNING Turning Inserts(Negative) VNMG Rhombic35°,with Hole
- GF for finishing of general steel and alloy steel.
- Sharp tool nose and strong cutting edge.
- Good chip control under small cutting depth.
- QF for finishing of general steel and alloy steel.
- Curved edge,sharp cutting edge, good chip control and fine surface finish due to curved edge.
- SF for stainless steel and Heat
- Sharp edge due to results in low cutting forces particularly for thin wall structures and extended shafts.
- GM for semi-finishing of general steel and alloy steel.
- Strong flat cutting edge.
- QM for semi-finishing of general steel and alloy steel.
- Gradient and waved hump wide applicable geometry range.
- TP For semi-finish machining of ordinary steel, alloy steel and cast iron.
- Double front angle, large blade width design, enhance the strength of the blade.
- Overall pattern design, stable and reliable installation.
- Arrow-shaped chipbreaker improves chipbreaking performance at large cutting depths.
- SM for medium cutting of stainless steel and mild steel.
- Sharp cutting edge.
SKU: Turning Inserts(Negative) VNMG Rhombic35°,with Hole 1
There are no reviews yet.